Question: How do you fix honeycomb on concrete surface?

What causes honeycombing in finished concrete?

WHAT CAUSES HONEYCOMBING? Honeycombing is caused either by the compaction not having been adequate to cause the mortar to fill the voids between the coarse aggregate, or by holes and gaps in the formwork allowing some of the mortar to drain out of the concrete.

What you mean by honeycomb in concrete?

Honeycomb is the rough pitted surface or voids in concrete formed due to improper compaction or incomplete filling of the concrete. In this formation, concrete not filled properly and create gaps/voids in between concrete and aggregates ( As shown in the above image).

How do you prevent honeycombing in concrete?

At places of junction of columns and beams, concrete with strictly 20 mm or less aggregates should be used with slightly more water and cement to avoid honeycombs. Taping the sides of shuttering from outside with wooden hammer during concreting and vibrating will help minimizing honeycombs to a great extent.

How do you prevent honeycomb in column concrete?

At places of junction of columns and beams, concrete with strictly 20 mm or less aggregates should be used with slightly more water and cement to avoid honeycombs. Taping the sides of shuttering from outside with wooden hammer during concreting and vibrating will help minimizing honeycombs to a great extent.

What type of structure is a honeycomb?

A honeycomb is a mass of hexagonal prismatic wax cells built by honey bees in their nests to contain their larvae and stores of honey and pollen.

What spalled concrete?

Spalling is the flaking or peeling away of small particles of cement paste from the near-surface portion of the finished slab. Finished concrete is often porous and can absorb rain water. Spalling occurs on exterior slabs when water that is trapped in the concrete goes through multiple freezes and thaws.

What does water damage look like on concrete?

If you see darkened and discolored areas, theres a good chance your floors are being damaged by moisture intrusion. Over time, water can delaminate the commercial floor paint from the surface, meaning the paint will lose its adhesion and begin to peel, chip, or flake away.

Write us

Find us at the office

Sandon- Prockish street no. 15, 58431 Kuala Lumpur, Malaysia

Give us a ring

Jhoanna Erwert
+95 242 472 567
Mon - Fri, 9:00-22:00

Join us